DO NOT use pliers or a wrench to tighten magazine cap. Slide the barrel into the receiver and tighten the magazine cap, finger tight only. Gently rotate the barrel back and forth while pushing the barrel into the receiver. Slide the barrel takedown mount ring over the magazine tube while guiding the barrel extension portion of the barrel into the receiver (Fig. Unscrew the magazine cap by turning it counterclockwise. 3) and move the forearm rearward until the front of the bolt is in the middle of the ejection port (Fig. 2).Īll Models: Depress the action lock lever, (Fig. Move the safety button fully rearward to the "ON" (SAFE) position (Fig.
Failure to do so may result in gun damage and/or personal injury if the shotgun is fired. If you are unable to remove all obstructions, bring the gun to a qualified gunsmith or ship it to the authorized Product Service Center. Visually inspect the inside of the barrel to make certain it is free of any obstructions, excessive oil or grease before installation.
#MOSSBERG 835 REASSEMBLY INSTALL#
To install the barrel in the receiver, proceed as follows: To facilitate shipping, some models are packaged with the barrel removed. 500, 835 and 590 barrels are interchangeable only with barrels of the same model, gauge and capacity.ĬAUTION: Never close the action or pull trigger while barrel is removed as damage could result to the firearm. Barrels are not interchangeable between model numbers, gauge or capacity.
0 kommentar(er)
